NEC DSX - Do Not Disturb; Enabling or Disabling Do Not Disturb

Do Not Disturb
Work by your phone undisturbed by incoming calls and announcements.
Do Not Disturb (DND) blocks incoming calls, Off-Hook Signaling and Paging announcements. You can activate DND anytime
while on a call or while your phone is idle. Once activated, incoming outside calls still flash your line keys. You may use your
phone normally for placing and processing calls.
Do Not Disturb provides the following 4 DND options:
(1) Incoming outside calls blocked.
(2) Incoming Intercom calls blocked
(3) All incoming calls blocked
(0) Cancel Do Not Disturb
Enabling or Disabling Do Not Disturb
To enable or disable Do Not Disturb:
1. While on-hook, press
DND.
2. Select the DND type.
a) Off = Turn DND off.
Alternately dial 0.
b) External (Ext) = Block incoming outside calls.
Alternately dial 1.
c) Intercom (Icm) = Block Intercom calls.
Alternately dial 2.
d) All = Block all incoming calls.
Alternately dial 3.
e) Room Monitor (Mon) = See Room Monitor on page 161.
If you don't select a type within 10 seconds:
• If DND is enabled, the system automatically disables DND for your extension.
• If DND is disabled, the system automatically enables DND type 3 for your extension.
3. Your telephone’s display shows the type of DND you enabled.
a) Your DND key is on.
If you are on a call (or anytime your telephone is not idle):
1. Do not hang up.
2. Press
DND.
a) If DND was enabled, the system automatically disables DND for your extension.
b) If DND was disabled, the system automatically enables DND type 3 for your extension.
82 | DSX | Features
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/