Conference
Set up a multiple-party telephone meeting without leaving the office. Conference lets you add additional inside and outside
callers to your conversation.
Using Conference
To set up a Conference:
1. Establish an Intercom or outside call.
2. Press
CONF.
a) Your hear Intercom dial tone.
b) Your caller hears Music on Hold (if installed) while they wait for you to set up the Conference.
3. Do one of the following:
a) Dial extension you want to add.
b) Place or answer an outside call.
c) Retrieve a call from Park Orbit.
4. Press CONF to set up the Conference.
a) If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
5. Repeat steps 2-4 to add additional parties to your Conference. You can also do one of the following.
a) To optionally place a Conference on Hold, press HOLD.
b) To reinstate the Conference on Hold, press CONF
6. To exit the Conference, hang up.
a) The remaining parties can continue their conversation uninterrupted.
b) If you were in Conference with two outside lines, this may set up a Tandem Calls / Unsupervised Conference
on page 173 (Unsupervised Conference).
DSX | Features | 59
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/
To Next Page
Loading...
