NEC DSX Feature Handbook

• Forced Account Codes do not apply to incoming calls.
To enter a Forced Account Code:
1. Access a line for an outgoing call.
a) You hear three beeps.
2. When your display shows Enter Account Code, enter the Account Code.
a) An Account Code can be up to 10 digits long, using the digits 0-9.
b) If your system has Verified Account Codes enabled, you must enter one from the Verified Account Codes
Table. If you enter an invalid Verified Account Code, your call will be cut off in the next step.
c) Skip this step to bypass Account Code entry (for example, when dialing a local call and your system requires
Account Codes only for toll calls).
3. Press an Account Code Feature Key or dial # (if enabled).
4. Dial your outside number.
a) Toll Restriction may still prevent you from dialing certain outside numbers.
b) If the number doesn't dial out within 6 seconds, your system probably has Store and Forward enabled. Just
dial # to have the call go through.
DSX | Features | 23
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/

NEC DSX Specifications