Issue 4.1 UNIVERGE SV8100
3 - 32 Installing the SV8100 Chassis
4. Align the bracket halves with the precut holes in the metal
expansion fitting provided (refer to Figure 3-35 9.5” Mounting
Brackets and Metal Expansion Fitting).
5. Secure the bracket halves to the expansion fitting using the
four supplied screws (refer to Figure 3-35 9.5” Mounting
Brackets and Metal Expansion Fitting on page 3-32).
6. Turn bracket assembly over and remove the screws holding
Figure 3-35 9.5” Mounting Brackets and Metal Expansion Fitting
To Next Page
Loading...
