UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 33
two brackets in the shipped position (refer to Figure 3-36
Brackets Secured in Mounting Position with Screws).
7. Rotate the brackets into the mounting position. Using the same
screws, secure the metal brackets to the bracket assembly
(refer to Figure 3-36 Brackets Secured in Mounting Position
with Screws).
8. Remove the end brackets from the remaining two corners and
set aside (refer to Figure 3-37 Remove End Brackets on page
3-34).
Figure 3-36 Brackets Secured in Mounting Position with Screws
To Next Page
Loading...
