UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 79
4.1.2 Install Cooling Fan
1. Align replacement fan with holes and secure with two screws
(refer to Figure 3-103 Chassis Access Panel Removed on page
3-78.
2. Install cabling into retention clips (refer to Figure 3-103 Chassis
Access Panel Removed on page 3-78
3. Insert access panel hinges into slots on rear of chassis.
4. Plug fan power cable into three prong plug (refer to Figure
3-102 Opening Chassis Access Panel (19” Chassis) on page
3-78).
5. Reinstall access cover and secure with retaining screw (refer to
Figure 3-101 19” Chassis Access Panel on page 3-77).
To Next Page
Loading...
