UNIVERGE SV8100 Issue 4.1
System Hardware Manual 5 - 63
10. Open the small door covering the side option
connectors by pulling the cover latch toward you
(refer to Figure 5-72 Serial Cable Installed, ITL,
DT700 only).
11. Connect the cable from the DCL-60-1 CONSOLE to
the Side Option Connector on the multiline terminal
and close the cover (ITL, DT700 only).
12. Set the height of the tilt leg on the multiline terminal
to the desired height.
13. Set the height of the tilt leg on the DCL-60-1
CONSOLE to match the tilt leg on the multiline
terminal.
14. Attach the side panel to the side of the DCL-60-1
CONSOLE.
15. Return the multiline terminal and DCL-60-1
CONSOLE to the buttons side up position.
16. Connect the digital cable to the LINE jack (DT300
Series).
17. Connect the AC Adapter cable (DT300/DT700
Series) See Figure 5-73 Connect AC Adapter Cable
on page 5-64.
Figure 5-72 Serial Cable Installed
To Next Page
Loading...
