NETGEAR GS324T User Manual

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure Switching User Manual115
• To configure all interfaces with the same settings, select the check box in the heading
row.
8. In the Description field, enter the description string to be attached to a port.
The string can be up to 64 characters in length.
9. From the Admin Mode menu, select Enable or Disable.
This selection specifies the administrative mode for port control. You must select Enable
in order for the port to participate in the network.
The default is Enable.
10. From the Autonegotiation
menu, select Enable or Disable.
This selection specifies the autonegotiation mode for the port. The default is Enable.
Note: After you change the autonegotiation mode, the switch might be
inaccessible for a number of seconds while the new settings take
effect.
11. In the Speed field, specify the speed value for the selected port.
Possible field values are as follows:
• Auto. All supported speeds.
•1
0. 10 Mbits/second
• 100. 100 Mbits/second
The delimiter characters for setting different speed values are a comma (,), a period (.)
and a space ( ). For you to set the autonegotiation speed, the autonegotiation mode must
be set to Enable.
The default is
Auto.
Note: After you change the speed value, the switch might be inaccessible for
a number of seconds while the new settings take effect.
12. From the Duplex Mode menu, select the duplex mode for the selected port.
The options are as follows:
• Half. Indicates that the interface supports transmission between the devices in only
one direction at a time.
• Full. Indicates that the interface supports transmission between the devices in both
directions simultaneously
.
•
Auto. Indicates that speed is set by the auto-negotiation process.
The default is Auto.
Note: After you change the duplex mode, the switch might be inaccessible
for a number of seconds while the new settings take effect.
13. From the Link Trap
menu, select whether or not to send a trap when the link status
changes.
By default, the switch sends a link trap.

NETGEAR GS324T Specifications

General

Switch type	Managed
Switch layer	L2/L3/L4
ARP inspection	Yes
Master (outer) case width	270 mm
Master (outer) case height	271 mm
Master (outer) case length	481 mm
Master (outer) case weight	8850 g
Harmonized System (HS) code	85176990
Quantity per master (outer) case	3 pc(s)
Package type	Box
Package depth	465 mm
Package width	229 mm
Package height	79 mm
Package weight	2710 g
Cables included	AC
Stackable	-
Product color	Black
Input current	5 A
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	13.5 W
Operating temperature (T-T)	0 - 40 °C
MAC address table	16000 entries
Power connector	AC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	24
Number of VLANs	256
Networking standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3az, IEEE 802.3x
Virtual LAN features	Private VLAN, Voice VLAN, Port-based VLAN
DHCP features	DHCP client

Weight and Dimensions

Depth	169 mm
Width	328 mm
Height	43 mm
Weight	1620 g