Configuring Switching
182
S3300 Smart Managed Pro Switch
5. In the Query Interval field, specify the time interval in seconds between periodic queries sent
by the snooping querier.
The Query Interval must be a value in the range of 1–1800 seconds. The default value is
60.
6. In the Querier Expiry Interval field, specify the time interval in seconds after which the last
querier information is removed.
The querier expiry Interval must be a value in the range of 60–300 seconds. The default
value is 60.
7. Click the Apply button.
Querier VLAN Configuration
Use this screen to configure MLD queriers for use with VLANs on the network.
To configure MLD queriers:
1. Select Switching> Multicast > MLD Snooping Querier > Querier VLAN Configuration.
2. In the VLAN ID field, specify the VLAN ID for which the MLD snooping querier is to be
enabled.
3. From the Querier Election Participate Mode list, select the mode:
• Disable. Upon seeing another querier of the same version in the VLAN, the snooping
querier moves to the non-querier state.
• Enable. The snooping querier participates in querier election, in which the least IP
address operates as the querier in that VLAN. The other querier moves to non-querier
state.
4. In the Querier VLAN Address field, specify the snooping querier IP address to be used as
the source address in periodic MLD queries sent on the specified VLAN.
5. Click the Add button.
To Next Page
Loading...
