Monitoring the System
332
S3300 Smart Managed Pro Switch
Trap Logs
Use the Trap Logs screen to view information about the SNMP traps generated on the switch.
To view trap log information, select Monitori
ng > Logs > Trap Logs. The Trap Logs screen
displays.
The following table describes the Trap Log in
formation displayed on the screen.
The screen also displays information about the traps that were sent.
Table 106. Trap log information
Field Description
Log The sequence number of this trap.
System Up Time The time at which this trap occurred, expressed in days, hours, minutes, and seconds
since the last reboot of the switch.
Trap Information identifying the trap.
Table 105. Trap log statistics
Field Description
Number of Traps Since
Last Reset
The number of traps that have occurred since the switch last reboot.
Trap Log Capacity The maximum number of traps stored in the log. If the number of traps exceeds the
capacity, the entries will overwrite the oldest entries.
Number of Traps Since
Log Last Viewed
The number of traps that have occurred since the traps were last displayed. Displaying
the traps by any method (such as terminal interface display, web display, or upload file
from switch) will cause this counter to be cleared to 0.
To Next Page
Loading...
