NETGEAR S3300 - Advanced Stack Configuration; Advanced Stack Status

Configure System Information
83
S3300 Smart Managed Pro Switch
Table 25. Basic Stack
Table 26.
Field Description
Unit ID The Unit ID of the specific switch.
Switch Description The description for the unit that
can be configured by the user.
Serial Number The unique box serial number for this switch.
Uptime Displays the relative time since the last reboot of the switch.
Preconfigured Model Identifier Displays the model type assigned by the device manufacturer to
identify
the device.
Plugged-in Model Identifier Displays the model type assigned by the device manufacturer to
ide
ntify the plugged-in device.
Detected Code Version Indicates the detected version of code on this unit.
Detected Code in Flash Displays the Release number and version number of the code
sto
red in flash.
SFS Last Attempt Status Displays the Stack Firmware Synchronization last attempt status.
Status
Click Update to update the page with the latest information on the switch.
Advanced Stack Configuration
Advanced > Stack Configuration uses the same screen as Basic > Stack Configuration
described above.
Advanced Stack Status
 Use the Stack Status page to display stack protocol information:
1. Click System > S
tacking > Advanced > Stack Status.
2. Select eith
er the Unit ID or All.
• Select
the Unit ID field to display information for the selected unit.
• Select Al
l to display information for all units.