NETGEAR S3300 - Page 84

Configure System Information
84
S3300 Smart Managed Pro Switch
Figure 47. Advanced Stack Status
The following table describes the non-configurable Advanced Stack Status data that is
displayed. Click Refresh to update the page with the latest information on the switch.
Table 27. Advanced Stack Status
Field Description
Unit ID The Unit ID of the specific switch.
Neighbor Unit ID The neighboring unit with which data is exchanged.
Current Current time of heartbeat messag
e reception.
Average Average time of heartbeat messages received.
Min Minimum time of heartbeat messages received.
Max Maximum time of heartbeat messages received.
Dropped Heartbeat message dropped or lost counter.
Clear Sampling Information
 To clear the sampling information:
The stack sampling parameters are configured on the Sy
stem > Stacking > Basic > Stack
Configuration page. See Stack Sample Mode o
n page 81.
1. Click Syste
m > Stacking > Advanced > Stack Status to display the sampling table.
See Figure 47 on
page 84.
2. In
the Clear sampling information > Clear counters field, select the unit to clear the
counters. Possible choices are None, a unit ID number, or All.
3. Click the Appl
y button to send the updated configuration to the switch. Configuration
changes take effect immediately.