NETGEAR S3300 - MVR Group Configuration

Configuring Switching
186
S3300 Smart Managed Pro Switch
MVR Group Configuration
Use the MVR Group Configuration screen to create and manage MVR groups on the switch.
In this example, five MVR groups are created. To create multiple MVR groups in the same
step, the groups must have contiguous IP addresses, such as 239.1.1.1, 239.1.1.2,
239.1.1.3, and so on.
 To configure five contiguous MVR groups:
1. Select Switch
ing > MVR Configuration > Advanced > MVR Group Configuration.
2. In
the MVR Group IP field, specify the lowest multicast IP group address in the block of
MVR group addresses.
3. In
the Count field, specify the number of addresses in the contiguous block.
In this example, the count is 5.
4. Click t
he Add button to add the five new MVR groups.
The following figure shows the five MVR groups th
at are created in this procedure.
Figure 88. MVR Group Configuration
The following table describes the status information that is displayed for each MVR group.
Table 66. MVR group status information
Field Definition
Status The status of the MVR group, which is either active or inactive.
Members The list of ports that participate in the MVR group.