NETGEAR S3300 - Traffic Control

Managing Device Security
264
S3300 Smart Managed Pro Switch
Traffic Control
From the Traffic Control menu, you can configure MAC Filters, Storm Control, Port Security,
and Protected Port settings.
The Traffic Control menu contains links to the features described in the following sections.
• MAC Filter:
• MAC Filter Configuration on page 264
• MAC Filter Summary on page 265
• Storm Control on page 266
• Port Security:
• Port Security Configuration on page 267
• Port Security Interface Configuration on page 267
• Security MAC Address on page 268
• Protected Ports Membership on page 269
MAC Filter Configuration
Use the MAC Filter Configuration screen to create MAC filters that limit the traffic allowed into
and out of specified ports on the system.
 To configure MAC filter settings:
1. Select Security > Traffic Control > MAC Filter > MAC Filter Configuration.
2. From the MAC Filter list, select Create Filter
If no filters have been configured, this is the only option available.
3. From the VLAN ID list, select the VLAN to use with the MAC address to fully identify packets
you want filtered.
You can change this field only when the Create Filter option is selected from the MAC
Filter menu.
4. In the MAC Address field, specify the MAC address of the filter in the format
00:01:1A:B2:53:4D.
You can only change this field when you have selected the Create Filter option.
You cannot define filters for the following MAC addresses:
• 00:00:00:00:00:00
• 01:80:C2:00:00:00 to 01:80:C2:00:00:0F
• 01:80:C2:00:00:20 to 01:80:C2:00:00:21
• FF:FF:FF:FF:FF:FF
5. From the list of Source Port Members, select the ports to include in the inbound filter.