EasyManuals Logo

NETGEAR S3300 User Manual

NETGEAR S3300
373 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #356 background imageLoading...
Page #356 background image
Configuration Examples
356
S3300 Smart Managed Pro Switch
Smart M4300/S3300 Firmware Upgrade Procedure
This section describes the firmware upgrade procedures in the following typical scenarios:
Bringing Up M4300 and S3300 to Form Mixed Stacking on page 356
Regular Image Upgrade After Mixed Stacking is Formed with 6.6.4 Image on page 358
Converting the M4300 Units Back Into Fully Managed M4300 Mode on page 359
Bringing Up M4300 and S3300 to Form Mixed Stacking
Because there is no hardware change in either M4300 or in S3300 products, the mixed
stacking capability is purely software controlled. In order to support mixed stacking between
M4300 and S3300, the software prerequisites are as follows:
M4300 labeled image 12.0.2.17 (or newer version)
M4300 labeled image 6.6.4.x (with typical filename m4300v6.6.4.x.stk)
S3300 labeled image 6.6.4.x (with typical filename S3300v6.6.4.x.stk)
There are two separate images, one for S3300 and another for M4300, as part of the 6.6.4.x
release.
Note: M4300 and S3300 should have the exact same version number in
order for them to mix stack successfully. For example, they both
should be loaded with the 6.6.4.1 version of the respective images. If
one device loads 6.6.4.1, and the other device loads 6.6.4.2, the mix
stack would report Code Mismatch and would not be operational.
Steps to Follow for M4300
1. Download the 12.0.2.17 (or newer version) image into a M4300-12X12F, or into a
M4300-24X, or into a homogeneous or heterogeneous stack of them
Note: This 12.0.2.17 image can also be downloaded into other M4300
models and that will not cause any issues. However, the 12.0.2.17
image will make sure that the 6.6.4.x image can be downloaded only
on M4300-12X12F and M4300-24X, and not in any other M4300
platforms.
2. Activate the 12.0.2.17 image and reload the unit or stack with it.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR S3300 and is the answer not in the manual?

NETGEAR S3300 Specifications

General IconGeneral
ModelNETGEAR S3300
CategorySwitch
VLAN SupportYes
Quality of Service (QoS)Yes
MAC Address Table Size16K
Uplink Ports4 x 10G SFP+
Switching Capacity128 Gbps
Forwarding Rate95.2 Mpps
LayerLayer 2+/Layer 3 Lite
ManagementWeb-based GUI, SNMP
Dimensions440 x 257 x 43 mm (17.32 x 10.12 x 1.69 in)
Jumbo Frame SupportYes
Operating Temperature0°C to 50°C (32°F to 122°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Humidity90% maximum relative humidity, noncondensing
Power SupplyInternal power supply
Power ConsumptionVaries by model
Ports24 or 48 x 10/100/1000BASE-T
Weight3.60 kg (7.94 lb)

Related product manuals