NETGEAR S3300 User Manual

Configuring Switching
195
S3300 Smart Managed Pro Switch
MRP Port Settings
Use the MRP Port Settings screen to configure the per-port MRP mode and timer settings.
The timers control when and how often various messages are transmitted on each interface.
 To configure the MRP port parameters:
1. Select Switching> MRP > Advanced > Port Settings.
2. Select the interfaces to configure.
For information about how to select and configure one or more ports, see Configuring
Interface Settings on page 32.
3. Configure the following MRP port settings:
a. Enable or disable MVRP on the interface.
b. Enable or disable MMRP on the interface.
c. Enable or disable MSRP on the interface.
d. Specify the value, in centiseconds, of the MRP Join Timer.
e. Specify the value, in centiseconds, of the MRP Leave Timer.
f. Specify the value, in centiseconds, of the MRP LeaveAll Timer.
g. In the MSRP SR class PVID field, specify the default VLAN ID to be used for MSRP
stream traffic.
ClassA/ClassB Boundary Port fields are not configurable and show whether the interface
is a boundary port.
4. Click the Apply button.

NETGEAR S3300 Specifications

General

Model	NETGEAR S3300
Category	Switch
VLAN Support	Yes
Quality of Service (QoS)	Yes
MAC Address Table Size	16K
Uplink Ports	4 x 10G SFP+
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Layer	Layer 2+/Layer 3 Lite
Management	Web-based GUI, SNMP
Dimensions	440 x 257 x 43 mm (17.32 x 10.12 x 1.69 in)
Jumbo Frame Support	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	90% maximum relative humidity, noncondensing
Power Supply	Internal power supply
Power Consumption	Varies by model
Ports	24 or 48 x 10/100/1000BASE-T
Weight	3.60 kg (7.94 lb)