Maintenance
308
S3300 Smart Managed Pro Switch
4. Use Count to enter the number of echo requests you want to send. The range is 1 to 15.
The default value is 3.
5. In the Interval field, specify the number of seconds between pings sent. The range is 1 to
60. The default value is 3.
6. In the Datagram Size field, specify the datagram size of the ping packet. The valid range is
0 to 13000. The default value is 0 bytes.
7. Enter the Source IP address or interface to use when sending the echo request packets. If
source is not required, select None as the source option. Possible values are:
• None — The source address of the ping packet would be the address of the default
outgoing interface.
• IPv6 Address — The source IPv6 address to use when sending the Echo request
packets. This field is shown when IPv6 Address is selected as the source option.
• Interface — The ping is sent from a specified interface. This field is shown when
Interface is selected as the source option. Use the menu to select the interface from
which to send the ping.
8. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
The switch sends the number of pings specified in the Count field, and the results are
displayed below the configurable data in the Result area:
• If the ping is successful, the output is “Send count=3, Receive count = n from (IPv6
Address).Average round trip time = n ms”.
• If a reply to the ping is not received, the following displays: “Reply From IP/Host:
Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec.”
9. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Traceroute IPv4
Use this screen to tell the switch to send a Traceroute request to a specified IP address or
Hostname. You can use this traceroute utility to discover the paths that an IPv4 packet takes
to a remote destination. Once you click the Apply button, the switch sends traceroute and the
results are displayed below the configurable data.
If a reply to the traceroute is received, you will see:
1 x.y.z.w 9869 usec 9775 usec 10584 usec
2 0.0.0.0 0 usec * 0 usec * 0 usec *
3 0.0.0.0 0 usec * 0 usec * 0 usec *
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
To configure the traceroute settings and send probe packets to discover the route to
an IPv4 address or host on the network:
1. Select Maintenance > Troubleshooting > Traceroute IPv4.
To Next Page
Loading...
Need help?
General
