NETGEAR S3300 - Configuring Interface Settings

Getting Started
32
S3300 Smart Managed Pro Switch
Configuring Interface Settings
For some features that allow you to configure interface settings, you can apply the same
settings simultaneously to any of the following:
• A single
port
• M
ultiple ports
• All p
orts
• A single
LAG
• M
ultiple LAGs
• All L
AGs
• Multiple port
s and LAGs
• All p
orts and LAGs
Many of the screens that allow you to configure or view interface settings include links to
displa
y all ports, all LAGs, or all ports and LAGs on the screen.
Figure 16. Links to Display Interfaces
Use these links as follows:
• T
o display all ports, click the 1 link.
• T
o display all LAGs, click the LAGS link.
• T
o display all ports and LAGs, click the All link.
The procedures in this section describe how to select the ports and LAGs to configure.
 To configure a single port by using the Go To Interface field:
1. Ensu
re that the screen is displaying all ports, and not only the LAGs.
2. In
the Go To Interface field, type the port number, for example g4.
3. Click the Go but
ton.
The check box associated with the interface is selected,
the row for the selected interface
is highlighted, and the interface number appears in the heading row.
Figure 17. Go To Interface Example