NETGEAR S3300 - USB Device Information

Configure System Information
45
S3300 Smart Managed Pro Switch
Figure 26. CPU Threshold
The CPU Threshold screen allows you to configure thresholds that, when crossed, trigger a
notification. The notification is done via SNMP trap and SYSLOG messages.
1. Def
ine the CPU Threshold fields listed in Table 10.
Table 10. System CPU Status > CPU Threshold
Field Description
Rising Threshold Notification is generated when the total CPU utilization exceeds this threshold
va
lue over the configured time period. The range is 1 to 100.
Rising Interval The utilization monitoring time period can be configured from 5 seconds to
86400 seconds in multiples of 5 seconds.
Falling Threshold Notification is triggered when the total CPU utilization falls below this level for a
co
nfigured period of time. The Falling utilization threshold must be equal or less
than Rising threshold value. The Falling utilization threshold notification is made
only if previously a Rising threshold notification was done. Configuring the
Falling utilization threshold and time period is optional. If the Falling CPU
utilization parameters are not configured, then it takes the same value as Rising
CPU utilization parameters. Range is 1 to 100.
Falling Interval The utilization monitoring time period ca
n be configured from 5 seconds to
86400 seconds in multiple of 5 seconds.
Free Memory Threshold This is non-configurable data and is the CPU Free Memory Threshold value.
2. Click the Apply button.
The system parameters are applied, and the device is updated.
3. Click the Canc
el button to cancel the configuration on the screen, and reset the data on the
screen to the latest value of the switch.
USB Device Information
Use the USB Device Information screen to display the USB device status, memory
statistics, and directory details.