NETGEAR S3300 - Display Auto-Voip Status

Configuring Switching
156
S3300 Smart Managed Pro Switch
authority. The switch comes preconfigured with the following OUIs that identify the IP phone
manufacturer:
• 00:01:E3: SIEMENS
• 00:03:6B: CISCO1
• 00:12:43: CISCO2
• 00:0F:E2: H3C
• 00:60:B9: NITSUKO
• 00:D0:1E: PINTEL
• 00:E0:75: VERILINK
• 00:E0:BB: 3COM
• 00:04:0D: AVAYA1
• 00:1B:4F: AVAYA2
• 00:04:13: SNOM
You can select an existing OUI or add a new OUI and description to identify the IP phones on
the network.
 To add a new OUI prefix:
1. Select Switching> Auto-VoIP> OUI-based > OUI Table.
2. In the Telephony OUI(s) field, specify the VOIP OUI prefix.
The OUI prefix must be in the format AA:BB:CC.
3. In the Description field, type a description that identifies the manufacturer or vendor
associated with the OUI.
The maximum length of description is 32 characters.
4. Click the Add button.
 To delete one or more OUI prefixes from the table:
1. Select the check box next to each OUI prefix to remove.
2. Click the Delete button.
Display Auto-VoIP Status
Use this screen to display Auto-VoIP status.To display the screen, click Switching >
Auto-VoIP > Auto-VoIP Status. A screen similar to the following is displayed.