NETGEAR S3300 - Policy Configuration

Configuring Quality of Service
235
S3300 Smart Managed Pro Switch
The same set of fields described for IPv6 ACL classification are also supported as match
criteria for DiffServ classes. Prior to the introduction of IPv6 class rule fields, any layer 3 or
layer 4 item was interpreted as a field in an IPv4 packet. To properly interpret the match
criteria fields and create classifier entries, it is necessary for the configuration to specify what
type of packet a class defines.
Policy Configuration
Use the Policy Configuration screen to associate a collection of classes with one or more
policy statements. After creating a Policy, click the policy link to the Policy screen.
 To create a new DiffServ policy:
1. Select Qo
S > DiffServ > Advanced > Policy Configuration.
2. Ente
r a policy name in the Policy Name field.
3. Select
the existing DiffServ class to associate with the policy.
4. Click the Ad
d button.
The available policy type is In, which indicates the type is sp
ecific to inbound traffic. This
field is not configurable.
 To rename an existing policy or add a new member class to the policy:
1. Select
the check box next to the configured class.
2. Upda
te the desired fields.
3. Click the Ap
ply button.
4. Click the Canc
el button to cancel the configuration on the screen, and reset the data on the
screen to the latest value of the switch.
 To delete a policy:
1. Click the check box
associated with the policy to remove.
2. Click the Del
ete button.
 To configure the policy attributes:
1. Click the na
me of the policy.
Figure 96. Policy Name