NETGEAR S3300 - Green Ethernet

Configure System Information
67
S3300 Smart Managed Pro Switch
 To change the host name or IP address in an entry:
1. Select the check box next to the entry to update.
2. Ente
r the new information in the appropriate field.
3. Click the Ap
ply button.
Green Ethernet
Use this screen to configure Green Ethernet features. Using the Green Ethernet
Configuration features allows for power consumption savings.
 To configure the Green Ethernet settings:
1. Select System > Managem
ent > Green Ethernet > Green Ethernet Configuration.
Figure 40. Green Ethernet Configuration
2. Enable or disable the Auto Power Down Mode.
• Enable. When
the port link is down, the PHY (physical layer device) will automatically
go down for a short period of time and then wake up to check link pulses. This allows
the port to continue to perform autonegotiation while consuming less power when no
link partner is present.
• Dis
able. Provide full power to the PHY even if the port link is down. The default is
Disable.
3. Enable
or disable the EEE Mode.
• Enable. Wh
en the send and receive sides of a link are lightly loaded, the port can
transition to low power mode to save power.
• Dis
able. Provide full power to the PHY regardless of the link load. The default is
Disable.
4. Click the Ap
ply button to send the updated configuration to the switch. Configuration
changes take effect immediately.
5. Click Canc
el to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Green Ethernet Interface Configuration
Use this screen to configure per-port Green Ethernet settings.
 To configure the Green Ethernet Interface settings:
1. Select Sy
stem > Management > Green Ethernet > Green Ethernet Interface
Configuration.