NETGEAR S3300 - Page 66

Configure System Information
66
S3300 Smart Managed Pro Switch
The Dynamic Host Configuration table shows host name-to-IP address entries that the switch
has learned. The following table describes the dynamic host fields:
Table 16. Dynamically learned host name mapping information
Field Description
Host Lists the host name you assign to the specified IP address.
Total Amount of time since the dynamic entry was first added to the table.
Elapsed Amount of time since the dynamic entry was last updated.
Type The type of the dynamic entry.
Addresses Lists the IP address associated with the host name.
Click Clear to delete dynamic host entries. The table will be repopulated with entries as they
are learned.
Configure and View Host Name-to-IP Address Information
Use this screen to manually map host names to IP addresses or to view dynamic DNS
mappings.
 To add a static entry to the local DNS table:
1. Select System
> Management > DNS > Host Configuration.
Figure 39. DNS Host Configuration
2. In the Host Name field, specify the static host name to add.
3. In
the IPv4/IPv6 Address field, specify the IP address to associate with the host name.
4. Click the Add but
ton.
 To remove an entry from the static DNS table:
1. Select the check box next
to the entry to remove.
2. Click the Delete butto
n.