NETGEAR S3300 User Manual

Managing Device Security
277
S3300 Smart Managed Pro Switch
MAC Binding Configuration
When an ACL is bound to an interface, all the rules that have been defined are applied to the
selected interface. Use the MAC Binding Configuration screen to assign MAC ACL lists to
ACL priorities and interfaces.
 To configure MAC ACL interface bindings:
1. Select Security > ACL > Basic > MAC Binding Configuration.
2. From the ALC ID menu, select the MAC ACL to bind to one or more interfaces.
The packet filtering direction for ACL is Inbound, which means the MAC ACL rules are
applied to traffic entering the port.
3. Specify an optional sequence number to indicate the order of this access list relative to other
access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If the sequence number is not specified by the
user, a sequence number that is one greater than the highest sequence number currently
in use for this interface and direction will be used. The valid range is 1–4294967295.
4. Click the appropriate selection to expose the available ports or LAGs.
• To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that a check mark displays in the box.
• To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. A check mark in the box indicates that the ACL
is applied to the interface.
5. Click the Apply button.
The Interface Binding Status section on the MAC Binding Configuration screen displays the
following information:
• Interface. The interface associated with the rest of the data.
• Direction. The packet filtering direction for ACL.
• ACL Type. The type of ACL assigned to selected interface and direction.
• ACL ID. The ACL number or name identifying the ACL assigned to selected interface and
direction.
• Sequence Number. The sequence number signifying the order of specified ACL relative
to other ACLs assigned to selected interface and direction.

NETGEAR S3300 Specifications

General

Model	NETGEAR S3300
Category	Switch
VLAN Support	Yes
Quality of Service (QoS)	Yes
MAC Address Table Size	16K
Uplink Ports	4 x 10G SFP+
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Layer	Layer 2+/Layer 3 Lite
Management	Web-based GUI, SNMP
Dimensions	440 x 257 x 43 mm (17.32 x 10.12 x 1.69 in)
Jumbo Frame Support	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	90% maximum relative humidity, noncondensing
Power Supply	Internal power supply
Power Consumption	Varies by model
Ports	24 or 48 x 10/100/1000BASE-T
Weight	3.60 kg (7.94 lb)