EasyManuals Logo

NETGEAR S3300 User Manual

NETGEAR S3300
373 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #216 background imageLoading...
Page #216 background image
Configuring Routing
216
S3300 Smart Managed Pro Switch
Configure Router Discovery
The Router Discovery protocol is used by hosts to identify operational routers on the subnet.
Router discovery messages are of two types: router advertisements and router solicitations.
The protocol mandates that every router periodically advertise the IP addresses it is
associated with. Hosts listen for these advertisements and discover the IP addresses of
neighboring routers.
Use the Router Discovery Configuration screen to enter or change router discovery
parameters.
To configure the router discovery parameters:
1. Select Routing > Router Discovery.
2. Select the router interface for which data is to be configured.
To perform the same configuration on all interfaces, select the check box in the heading
row. To configure a single interface, select the check box associated with the interface.
The interface number displays in the Interface field in the table heading row.
3. From the Advertise Mode list, select Enable.
Router advertisements are transmitted from the selected interface.
4. In the Advertise Address field. specify the IP address to be used to advertise the router.
5. In the Maximum Advertise Interval field, specify the maximum time (in seconds) allowed
between router advertisements sent from the interface.
6. In the Minimum Advertise Interval field, specify the minimum time (in seconds) allowed
between router advertisements sent from the interface.
7. In the Advertise Lifetime field, specify the value (in seconds) to be used as the lifetime field
in router advertisements sent from the interface.
This is the maximum length of time that the advertised addresses are to be considered as
valid router addresses by hosts.
8. In the Preference Level field, specify the preference level of the router as a default router
relative to other routers on the same subnet.
Higher numbered addresses are preferred. You must enter an integer.
9. Click the Apply button.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR S3300 and is the answer not in the manual?

NETGEAR S3300 Specifications

General IconGeneral
ModelNETGEAR S3300
CategorySwitch
VLAN SupportYes
Quality of Service (QoS)Yes
MAC Address Table Size16K
Uplink Ports4 x 10G SFP+
Switching Capacity128 Gbps
Forwarding Rate95.2 Mpps
LayerLayer 2+/Layer 3 Lite
ManagementWeb-based GUI, SNMP
Dimensions440 x 257 x 43 mm (17.32 x 10.12 x 1.69 in)
Jumbo Frame SupportYes
Operating Temperature0°C to 50°C (32°F to 122°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Humidity90% maximum relative humidity, noncondensing
Power SupplyInternal power supply
Power ConsumptionVaries by model
Ports24 or 48 x 10/100/1000BASE-T
Weight3.60 kg (7.94 lb)

Related product manuals