NETGEAR S3300 User Manual

Configure System Information
106
S3300 Smart Managed Pro Switch
Local Information
Use the LLDP Local Information screen to view the data that each port advertises through
LLDP. To view local LLDP information, select System > Advanced > LLDP > Local
Information.
Note: The screen includes only the interfaces on which LLDP is enabled.
Extended PoE This table specifies if the remote device is a PoE device.
Device Type Specifies the remote device’s PoE device type connected to this port.
Extended PoE PSE This table specifies if the extended PSE TLV is received in an LLDP frame on
this port.
Device Type Specifies the remote device’s PoE device type connected to this port.
Power Source Specifies the remote port’s PSE power source.
Power Priority Specifies the remote port’s PSE power priority.
Power Value Specifies the remote port’s PSE power value in tenths of watts.
Extended PoE PD This table specifies if extended PD TLV is received in an LLDP frame on this
port.
Device Type Specifies the remote device’s PoE device type connected to this port.
Power Source Specifies the remote port’s PD power source.
Power Priority Specifies the remote port’s PD power priority.
Power Value Specifies the remote port’s PD power value.
Table 35. LLDP-MED Neighbors Information (continued)
Field Description

NETGEAR S3300 Specifications

General

Model	NETGEAR S3300
Category	Switch
VLAN Support	Yes
Quality of Service (QoS)	Yes
MAC Address Table Size	16K
Uplink Ports	4 x 10G SFP+
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Layer	Layer 2+/Layer 3 Lite
Management	Web-based GUI, SNMP
Dimensions	440 x 257 x 43 mm (17.32 x 10.12 x 1.69 in)
Jumbo Frame Support	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	90% maximum relative humidity, noncondensing
Power Supply	Internal power supply
Power Consumption	Varies by model
Ports	24 or 48 x 10/100/1000BASE-T
Weight	3.60 kg (7.94 lb)