NETGEAR S3300 - Trap Configuration

Configure System Information
96
S3300 Smart Managed Pro Switch
If you select Enable, the community name must be unique among all valid community
names or the set request will be rejected. If you select Disable, the community name will
become invalid.
7. Click the Add but
ton.
 To modify an existing community:
1. Select the check box next
to the community.
2. Update
the desired fields.
3. Click the Appl
y button.
 To delete a community:
1. Select the check box next
to the community to remove.
2. Click the Delete butto
n.
Trap Configuration
Use this screen to configure settings for each SNMPv1 or SNMPv2 management host that
will receive notifications about traps generated by the device. The SNMP management host
is also known as the SNMP trap receiver.
 To add an SNMP trap receiver:
1. Select System > SNMP > SN
MP V1/V2 > Trap Configuration
Figure 54. Trap Configuration
2. In the Recipients IP field, specify the IP address in x.x.x.x format to receive SNMP traps
from this device.
3. From t
he Version list, select the trap version to be used by the receiver.
• SNMP v1. T
he switch uses SNMP v1 to send traps to the receiver.
• SNMP v2. T
he switch uses SNMP v2 to send traps to the receiver.
4. I
n the Community String field, specify the name of the SNMP community that includes the
SNMP management host and the SNMP agent on the device.
5. From
the Status list, select Enable to send traps to the receiver.
6. Click the Add but
ton.
 To modify information about an existing SNMP recipient:
1. Select the check box next
to the recipient.
2. Update
the desired fields.