NETGEAR S3300 - Page 46

Configure System Information
46
S3300 Smart Managed Pro Switch
 To display the USB Device Information page:
1. Select System > Management > USB Device Information.
2. Th
e USB Device Information screen displays as shown in Figure 27, USB Device
Information.
3. Click Up
date to update the information on the page to the latest data on the switch.
Note: The system only detects and manages the USB device installed in the
master unit.
The limitations for the USB Device supported on the S3300 are as follows:
• The USB disk
should comply for USB 2.0.
• The USB disk
should have a filetype of FAT32 or VFAT. NTFS is not supported.
• The write/read
speed is about 1 Mbps due to a hardware limitation.
Figure 27. USB Device Information
Table 11 describes the nonconfigurable information that the USB Device Information screen
displays.
Table 11. USB Device Information
Field Description
USB Device Details
Device Status Specifies the current status of device.
• Ac
tive if the device is USB plugged in and recognized by the switch.
• In
active if the device is not mounted.
• Invalid if the device is not present or an invalid device is plugged in.
USB Memory Statistics
Total Size Displays the USB flash device stor
age size in bytes.