NETGEAR S3300 - Page 334

Monitoring the System
334
S3300 Smart Managed Pro Switch
Figure 117. Port Mirroring
2. In the Global Configuration section of the screen, click the option to enable (True) or disable
(False) the Admin Mode for the current session. When Admin Mode is enabled, any traffic
entering or leaving the source ports of the current session is copied (mirrored) onto the
corresponding destination port. The default mode is disabled (False).
3. In
the Destination Interface list, select the destination interface (port) to which port traffic is
be copied. The default value is None.
4. Select the Fil
ter Type to configure IP or MAC ACLs which can mirror traffic that matches a
permit rule. Possible values are:
• None. No filter is configured
for the session.
• IP ACL. Config
ure IP ACL.
• MAC ACL. Config
ure MAC ACL.
5. In
the Filter Name field, enter the name of the filter, if it is configured for the session.
6. In
the Source Interface Configuration section of the screen, select the source port or ports.
You can configure multiple ports and LAGs as source ports. The CPU port can also be
con
figured as a source port. When the CPU is a source port, traffic received or sent by
the CPU is mirrored to the probe port.
a. Disp
lay the ports or LAGs to configure as source ports.
To display physical interfaces, LAGs, or both, click
one of the following links above the
table heading:
• 1. Only physical interfa
ces are displayed. This is the default setting.
• LAGS. Only link a
ggregation groups are displayed.