Configure System Information
54
S3300 Smart Managed Pro Switch
3. In the Date field, enter the date in the DD/MM/YYYY format.
4. In
the Time field, enter the time in HH:MM:SS format.
Note: If you do not enter a date and time, the switch will calculate the date
and time using the CPU’s clock cycle.
5. Click the Apply button.
To configure the time by using SNTP:
1. Select System > Manage
ment > Time > Time Configuration.
2. Next to Clock Source, select the SN
TP radio button.
The screen refreshes and displays the SNTP Global Configuration screen.
Figure 32. Time > SNTP Global Configuration
3. Next to Client Mode, select the mode of operation of the SNTP client:
• Disa
ble. SNTP is not operational. No SNTP requests are sent from the client nor will
any received SNTP messages be processed.
• Unicast.
SNTP operates in a point-to-point fashion. A unicast client sends a request
to a designated server at its unicast address and expects a reply from which it can
determine the time and, optionally the round-trip delay and local clock offset relative
to the server.
• Broa
dcast. SNTP operates in the same manner as multicast mode but uses a local
broadcast address, instead of a multicast address. The broadcast address has a
single subnet scope while a multicast address has Internet wide scope.
The default value is Disab
le.
To Next Page
Loading...
