Configure System Information
94
S3300 Smart Managed Pro Switch
Status Operational status of the port PD detection. Possible values are:
• Disabled. Indicates that no power is being delivered.
• Delivering Power. Indicates that power is being drawn by the
device.
• Fault. Indicates a problem with the power.
• Other Fault. Indicates that the port is idle due to an error
condition.
• Requesting Power. Indicates that the port is requesting power.
• Searching. Indicates that the port is not in one of the other
states in this list.
• Test. Indicates that the port is in Test mode.
Fault Status Describes the error description when the PSE port is in fault status.
Possible values are:
• No Error. Specifies that the PSE port is not in any error state
• MPS Absent. Specifies that the PSE port has detected an
absence of main power supply.
• Short. Specifies that the PSE port has detected a short circuit
condition.
• Overload. Specifies that the PD connected to the PSE port has
tried to provide more power than is permissible by the
hardware.
• Power Denied. Specifies that the PSE port has been denied
power because of a shortage of power, or due to
administrative action.
Table 32. PoE Port Configuration Non-Configurable Data (continued)
Field Description
To Next Page
Loading...
