The Design View Toolbars
58 Chapter 4
The Design View Toolbars
This section describes each toolbar in design view and defines its
buttons. There are seven toolbars:
• The design toolbar
• The font/text toolbar
• The drawing toolbar
• The arrange toolbar
• The proofing toolbar (See “Proofing a Form” on page 32 for
information on this toolbar and its functions.)
• The calculation toolbar (See Chapter 8, “Using Calculations,” for
information on this toolbar and its functions.)
• The web toolbar (See “The Web Toolbar” on page 52 for more
information about this toolbar and its functions.)
You can drag these toolbars to any other location in the OmniForm
window.The toolbars remain where you last positioned them, even
when you close and reopen the program.
You can also move the toolbars from a horizontal position to a vertical
position. In this case, some of the icons may change. See the specific
toolbars for information on which icons may change.
Customizing Toolbars
There are several ways to customize the toolbars.
• To move toolbar buttons to other toolbars, simply drag the button
you want (by holding down the ALT key and clicking on a button)
to the desired location on another toolbar.
• You can toggle the visibility of the toolbars on your desktop by
selecting the
To o l b a r s
command in the View menu. In the popup
menu that appears, select the toolbars that you want displayed on
your desktop; or, deselect those that you do not want displayed on
your desktop.
• You can right-click on the perimeter of the main window to get a
shortcut menu for toggling the visibility or customizing the
toolbars.
• You can customize the toolbars by using the
Customize...
command in the Tools menu. See the next sections “To customize
toolbars using the
To o l ba r s
tab:” and “To customize toolbars using
the
Commands
tab.”
To Next Page
Loading...
Need help?
General
