Oce TCS500 - Page 91

91
The user interface of the Océ System Control Panel
[33]
The status bar
The status bar at the bottom of the Océ System Control Panel displays the following.
■ The system status (connected or disconnected).
■ The system name ('Localhost' if you work on the Océ Power Logic
®
controller).
■ The user mode (Key operator, Repro operator, System administrator, Service
operator or 'Anonymous').
[34]
[33] The buttons of the toolbar
Item Function
'Printer' View the status of the printer. If the printer operator panel displays
an error, the 'Printer' status window of the Océ System Control Panel
will display the same error.
'Media' View the status of the media (available, empty or disabled). The
'Media' display also shows information about the available media
sizes and media types.
Note: When a roll is disabled, the roll icon is grayed out.
The text 'Disabled' replaces the media information.
'Ink' View the ink levels of the four colors.
'Scanner' View the status of the scanner.
'Controller' View the status of the controller.
'Memory' Check the amount of set memory that is available. The percentage
on the right-hand side of the set memory meter indicates the amount
of set memory in use. The colors indicate the following.
■ Green indicates that the set memory has sufficient space for a
large print job or many small jobs.
■ Orange indicates that the set memory approaches the red zone.
Large print jobs may not be possible.
■ Red indicates that the set memory is (nearly) full. The system
does not accept new print jobs. Remove files or wait until files
are printed and automatically removed from the memory.
Note: Define the threshold values for the orange zone
and the red zone in the Océ Settings Editor.
[34] The icons of the status bar
Icon Function
[55]
The Océ System Control Panel is connected to a system.
[56]
The Océ System Control Panel is not connected to a system.