Oki C650 - Page 109

Changing settings from the operator panel
- 109 -
Item
Factory
default
settings
Description
Error Report (Fn210) Off Sets whether to print an error report when
an internal error occurs.
Hex Dump (Fn237) Execute Prints the data received from the PC in
hexadecimal dump. To exit this mode, turn
off the power.
Print Adjust Print Position
Adjust
MPTray
(Fn220)
X Adjust 0.00millimete
r
Adjusts the printing position of each tray.
• X Adjust: Corrects the position of the
entire print image perpendicularly to the
paper travel direction.
Value range: ±2.00 mm (in increments of
0.25 mm)
• Y Adjust: Corrects the position of the entire
print image along the paper travel direction.
Value range: ±2.00 mm (in increments of
0.25 mm)
• Duplex X Adjust: Corrects the position of
the entire print image at the right angle to
the paper travel direction for printing the
face side during duplex printing (when
printing the print side of paper fed from the
duplex unit).
Value range: ±2.00 mm (in increments of
0.25 mm)
• Duplex Y Adjust: Corrects the position of
the entire print image along the paper travel
direction for printing the face side during
duplex printing (when printing the print side
of paper fed from the duplex unit).
Value range: ±2.00 mm (in increments of
0.25 mm)
Tray 2/3/4 is displayed when the expansion
tray is mounted.
Y Adjust 0.00millimete
r
Duplex X
Adjust
0.00millimete
r
Duplex Y
Adjust
0.00millimete
r
Tray1
(Fn221)
X Adjust 0.00millimete
r
Y Adjust 0.00millimete
r
Duplex X
Adjust
0.00millimete
r
Duplex Y
Adjust
0.00millimete
r
Tray2
(Fn222)
X Adjust 0.00millimete
r
Y Adjust 0.00millimete
r
Duplex X
Adjust
0.00millimete
r
Duplex Y
Adjust
0.00millimete
r
Tray3
(Fn223)
X Adjust 0.00millimete
r
Y Adjust 0.00millimete
r
Duplex X
Adjust
0.00millimete
r
Duplex Y
Adjust
0.00millimete
r
Tray4
(Fn224)
X Adjust 0.00millimete
r
Y Adjust 0.00millimete
r
Duplex X
Adjust
0.00millimete
r
Duplex Y
Adjust
0.00millimete
r
Paper Black Setting (Fn230) 0 Used for fine adjustment in case of
noticeable blur etc. in the print results during
mono printing when [Plain] is selected as
[Media Type]. Decreases the value if
printing such as scattered or snow-covered
printing occurs in high-density printing.
Increases the value if printing is blurred.
Adjusts within the range of ±2.