6-38
n113
Slip Compensation During
Regeneration
Register 0171 Hex Changes during
operation
No
Setting
range
0, 1 Unit of
setting
1 Default setting 0
Set Values
Value Description
0 Slip compensation function disabled during regeneration
1 Slip compensation function enabled during regeneration
• Select whether the slip compensation function is enabled or not, even during regeneration (i.e.: when
regeneration energy is returning during deceleration, etc.).
• This parameter is only enabled in vector control mode. (In V/f control mode, the slip compensation
function will be disabled during regeneration, regardless of the setting for this parameter.)
Advanced Operation Chapter 6
To Next Page
Loading...
