Omron SYSDRIVE 3G3MV SERIES User Manual

3-10
3-2 Parameter Copy and Verify Function
The Digital Operator of the 3G3MV Inverter has an EEPROM in which the set values in
all the parameters and data on the capacity and software version of the Inverter can be
stored.
By using the EEPROM, most parameter set values in the Inverter can be copied to
another Inverter.
Note In the above case, however, the Inverters must have the same power supply spec-
ification and control mode (i.e., V/f or vector control mode). Some types of param-
eter set values cannot be copied.
3-2-1 Parameter for Copying and Verifying Set Values
• Use the following parameter to read, copy, and verify the set values.
Parame-
ter
Register Name Description Setting
range
Unit of
setting
Default
setting
Chan-
ges dur-
ing
opera-
tion
n176 01B0 Parame-
ter copy
and
verify
function
selection
The following items are
selectable.
rdy: Ready to accept the
next command
rEd: Reads the parameter
CPy: Copies the parameter
vFy: Verifies the parameter
vA: Displays the capacity of
the Inverter
Sno: Displays the software
version.
rdy to
Sno
--- rdy No
Preparing for Operation and Monitoring Chapter 3

Omron SYSDRIVE 3G3MV SERIES Specifications

General

Model	SYSDRIVE 3G3MV SERIES
Category	Inverter
Input Frequency	50/60 Hz
Output Frequency	0.1 to 400 Hz
Cooling Method	Forced Air Cooling
Input Voltage	200 to 240 VAC, 380 to 480 VAC
Horsepower Range	0.1 to 15 HP
Power Range	0.1 to 11 kW
Overload Capacity	150% for 60 seconds
Braking Unit	Built-in
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication	RS-485
Ambient Temperature	-10 to 50°C
Storage Temperature	-20 to 65°C
Humidity	5 to 95% RH (non-condensing)
Vibration	5.9 m/s² or less
Voltage Class	200V, 400V