9-19
H Dimensions (mm)
3G3IV-PEZZ08386A
Four 4.4 dia. mm mounting holes
Four M4 nut countersinks 3.5 mm deep
H Control Panel Mounting Procedures
The 3G3IV-PJVOP146 Digital Operator and the 3G3IV-PJVOP140 Digital Operator in a 3G3IV-
PEZZ08386A casing can be mounted to the front or back of a control panel.
Front mounting procedure
Rear mounting procedure
Panel cutout dimensions for front mounting
Panel cutout dimensions for rear mounting
Mounting panel
(Packing A)
Digital Operator attachment
(Rubber
washer)
Fastening
screws
Panel
cutout
Four 3.5 mm
radius max.
Cut off the area marked by diagonal lines to
make room for the CN2 connector.
Tap, four M4 holes
M4 nuts
(Rubber washer)
Digital Operator attachment
(Packing B)
Mounting panel
Fastening screws
Panel
cutout
Six 3 mm
radius max.
Four 4.3 dia. mounting holes
Specifications
Chapter 9
To Next Page
Loading...
