Omron V1000 User Manual

8.5 Communication Options
Table 8.2 gives detailed information about the available options that allow OYMC drives to connect to communication
networks. A host controller can control and monitor the drive, read and change parameters by using a communication
option.
• Option Selection: Refer to OYMC catalog for more details on option card selection and part numbers.
• Option Installation: Refer to option unit manual for option unit installation instructions.
Table 8.2 Available Communication Options
Option Model Function
PROFIBUS-DP
Communications Card
SI-P3/V Connects to a PROFIBUS-DP network
CC-Link Communications
Card
SI-C3/V Connects to a CC-Link network
DeviceNet Communications
Card
SI-N3/V Connects to a DeviceNet network
CANopen Communications
Card
SI-S3/V Connects to a CANopen network
Ethernet/IP
Communications Card
SI-EN3/V
<1>
Connects to an Ethernet/IP network
Mechatrolink-II
Communications Card
SI-T3/V
<1>
Connects to a Mechatrolink-II network
<1> Under development
8.5 Communication Options
SIEP C710606 20 OYMC AC Drive - V1000 User Manual
283
8
Peripheral Devices & Options
7/16/2008-13:23

Omron V1000 Specifications

General

Cooling Method	Fan cooling
Enclosure Rating	IP20
Communication	Modbus RTU
Output Power	0.4-15kW
Output Frequency Range	0 to 400 Hz
Overload Capacity	150% for 60 seconds
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +65°C
Humidity	5 to 95% RH (non-condensing)
Supply Voltage	200-240V AC (3-phase)