Configure ssctuner to Run compliance(1M) Benchmarks
The NFS_EXCLUDE, NFS_INCLUDE and ZPOOL_NAME_CUST properties must be simple strings but
you can use simple regular expressions.
If you need the flexibility of regular expressions, be extremely careful to double quote the
expressions. Also verify that the ssctuner service comes back after restarting and no errors are
in the SMF log file.
3.
Restart the SMF service for changes to take effect.
# svcadm restart ssctuner
4.
Ensure that the ssctuner service is enabled and no error messages are reported.
If you changed a property using an incorrect syntax, the service does not come back. If this
happens, identify the offending property that you must fix:
# grep -i parameter /var/svc/log/site-application-sysadmin-ssctuner:default.log
After making any corrections or changes, repeat Step 3.
Related Information
■
“ssctuner Overview” on page 159
■
“Monitor ssctuner Activity” on page 160
■
“View Log Files” on page 161
■
“Configure the EMAIL_ADDRESS Property” on page 162
■
“Configure ssctuner to Run compliance(1M) Benchmarks” on page 165
■
“Monitor and View the Compliance Benchmark” on page 166
■
“Install ssctuner” on page 168
■
“Enable ssctuner” on page 169
Configure ssctuner to Run compliance(1M)
Benchmarks
Use this procedure to configure ssctuner to run compliance benchmarks.
The assessment begins within 12 minutes and then to reruns after each time the node is
rebooted.
Maintaining the System 165
To Next Page
Loading...
Need help?
General