Configure SNMP Trap Destinations for Exadata Storage Servers
5. Configure and activate SuperCluster ASR assets.
Refer to ASR documentation and tasks in this section.
Note - An active ASR Manager must be installed and running before you configure ASR
assets.
Note - To monitor Oracle Solaris 10 assets, you must install the latest STB bundle on
SuperCluster. Refer to Doc ID 1153444.1 to download the latest STB bundle from MOS:
https://support.oracle.com
6. Approve ASR assets in MOS.
Follow the instructions in the ASR documentation.
Configure SNMP Trap Destinations for Exadata
Storage Servers
Note - Do not attempt to copy and paste commands that span across multiple lines from this
section. Manually type commands that span across multiple lines to ensure the commands are
typed properly.
Complete the following steps on each Exadata Storage Server:
1.
Log in as celladmin on the Exadata Storage Server.
2.
On the Exadata Storage Server, add SNMP trap destinations:
# cellcli -e “alter cell snmpSubscriber=(host ='ASR-Manager-name-or-IP-address',port=162,
community=public,type=asr)”
Note that single quotes are required around the ASR-Manager-name-or-IP-address entry.
Following are the element definitions for the command above:
■
host='ASR-Manager-name-or-IP-address' – The ASR Manager hostname can be used when
DNS is enable for the site. If DNS is not running, the IP address is preferred, but the ASR
Manager hostname can be used if the entry is added to the /etc/hosts file.
■
type=asr – Shows the ASR Manager as being a special type of SNMP subscriber.
■
community=public – The required value of the community string. This value can be
modified to be a different string based on customer network requirements.
208 Oracle SuperCluster T5-8 Owner's Guide • May 2016
To Next Page
Loading...
Need help?
General