Oracle SuperCluster T5-8 User Manual

Prepare DNS for the System
Parameter Comments Full Rack Half Rack
8 x 10 GB if using two connections per
SPARC T5-8
32 x 10 GB if using four connections
per SPARC T5-8
4 x 10 GB if using two connections
per SPARC T5-8
16 x 10 GB if using four
connections per SPARC T5-8
†
You will not have redundancy using IPMP if there is only one connection per SPARC T5-8.
Related Information
■
“Network IP Address Requirements” on page 114
■
“Prepare DNS for the System” on page 114
■
“Understanding the Network Requirements” on page 86
Network IP Address Requirements
For Oracle SuperCluster T5-8, the number of IP addresses that you will need for each
network varies depending on the type of configuration you choose for your system. For
more information on the number of IP addresses required for your configuration, refer to the
appropriate configuration worksheet.
Related Information
■
“Network Connection Requirements” on page 113
■
“Prepare DNS for the System” on page 114
■
“Understanding the Network Requirements” on page 86
Prepare DNS for the System
Before You Begin
You must finish the following tasks before the system arrives. Installation and the initial
configuration cannot proceed until these tasks are finished.
Note - Grid Naming Service (GNS) is not configured on the rack until after initial
configuration.
1.
Provide the necessary information in the following documents:
■
Oracle SuperCluster T5-8 Site Checklists
114 Oracle SuperCluster T5-8 Owner's Guide • May 2016

Oracle SuperCluster T5-8 Specifications

General

Brand	Oracle
Model	SuperCluster T5-8
Category	Server
Language	English