Oracle SuperCluster T5-8 User Manual

Configuring SDP-Enabled JDBC Drivers for Dept1_Cluster1
■
In ONS host and port, enter a comma-separate list of ONS daemon listen addresses and
ports for receiving ONS-based FAN events. You can use Single Client Access Name
(SCAN) addresses to access FAN notifications.
■
Click Next.
11.
On the Test ONS client configuration page, review the connection parameters
and click Test All ONS Nodes.
Click Next.
12.
In the Select Targets page, select Dept1_Cluster1 as the target and All Servers in
the cluster
13.
Click Finish.
14.
Click Activate Changes.
15.
Now you must configure SDP-enabled JDBC drivers for the cluster.
For instructions, go to “Configuring SDP-Enabled JDBC Drivers for
Dept1_Cluster1” on page 238.
Configuring SDP-Enabled JDBC Drivers for Dept1_Cluster1
You must configure SDP-enabled JDBC drivers for the Dept1_Cluster1 cluster.
This section discusses the following topics:
■
“Configure the Database to Support Infiniband” on page 238
■
“Enable SDP Support for JDBC” on page 239
■
“Monitor SDP Sockets Using netstat on Oracle Solaris” on page 240
Configure the Database to Support Infiniband
Before enabling SDP support for JDBC, you must configure the database to
support InfiniBand, as described in the " Configuring SDP Protocol Support for
Infinband Network Communication to the Database Server" section in the Oracle
Database Net Services Administrator's Guide, located at:
http://download.oracle.com/docs/cd/B28359_01/network.111/b28316/performance.
htm#i1008413
238 Oracle SuperCluster T5-8 Owner's Guide • May 2016

Oracle SuperCluster T5-8 Specifications

General

Brand	Oracle
Model	SuperCluster T5-8
Category	Server
Language	English