ORTEC radEAGLE - Send Data; Collected Measurements; Checking the Internet Connection

5.26 Send Data radEAGLE User Manual
Figure 89: Collected measurements
5.26 Send Data
You can sent saved spectra (see 5.1, p. 44) or reachback data sets (see 5.25, p. 76) via
e-mail with this command.
Sending mail is possible only while your radEAGLE is connected to the Internet, so this is
checked first, Fig. 90, p. 78.
Figure 90: Checking the Internet connection
If there is no connection you are routed to the appropriate settings screens to configure a
connection, Fig. 91, p. 79 (see 5.7, p. 52).
78/147 Software 3.2.12 • Document 3.3.0o © innoRIID GmbH • 2019-04-11