ORTEC radEAGLE - About

radEAGLE User Manual radEAGLE Advanced Menu
Multichannel Analyzer, Geiger-Müller Detector, Neutrondetector
Several features of these components are tested and the result is shown after a while:
Passed
No problems detected.
Failed
Problems detected. Please take a note of the circumstances and displayed
messages and contact our service department. See p. 2 for addresses.
Check Calibration
You should check the calibration of your instrument (see D.1, p. 131).
Battery
The battery is checked and the result is shown after a while.
This test yields meaningful results only while a black powerCELL (see 8.1.1,
p. 107) is mounted in the radEAGLE.
Passed
No problems detected.
Failed
Problems detected. Try replacing the battery (see 8.2, p. 109). Please take
a note of the circumstances and displayed messages and contact our service
department. See p. 2 for addresses.
Display, LEDs, Vibrator, Speaker
These tests activate the annunciators of the instrument and expose several visual
and audible patterns.
Vibrator and speaker are activated regardless of your settings (see 5.5, p. 50).
Please verify that the annunciators of the radEAGLE behaves as announced.
If not: Please take a note of the circumstances and displayed messages and contact
our service department. See p. 2 for addresses.
Exit
Return to the superior screen.
5.28 About
This screen (Fig. 96, p. 82) shows information about your radEAGLE. Please have these data
at hand when contacting our support.
Settings and Commands
Exit
Return to the superior screen.
© innoRIID GmbH • 2019-04-11 Software 3.2.12 • Document 3.3.0o 81/147