OutBack Power MATE3 User Manual

Charge Controller Settings
900-0117-01-00 Rev B 101
Reset Charge Controller to Factory Defaults
This menu allows the user to erase all settings from the selected charge controller and start over with the
values programmed at the factory. These values are listed in the charge controller Owner’s Manual.
Figure 122 Restoring the Charge Controller to Factory Default Settings
Press <Continue> to return to the
Charge Controller menu.
To access the Reset to Factory Defaults menu:
1. Access the Main Menu as shown in Figure 71.
2. Select the Settings Menu . (This option may be
highlighted by default.)
3. Select
Charge Controller in the device
Settings Menu .
4. Select the Reset to Factory Defaults menu.
5. Use the soft keys to select
No or Yes .
 If <No> is selected, the screen returns to the
Inverter menu. No changes will be made to
any settings.
 If <Yes> is selected, the inverter’s settings will
immediately change to the original factory values.
The screen will display the message
Charge
Controller Restored to Factory Defaults.
A
<Continue> soft key will appear. Pressing this
key will return the screen to the
Charge
Controller
menu.
6. After resetting the inverter to factory default
parameters:
 press the <Continue> soft key or the Up
navigation key to return to the Charge
Controller
menu, or
 press the Top navigation key to return to the
Settings Menu .

OutBack Power MATE3 Specifications

General

Brand	OutBack Power
Model	MATE3
Category	Controller
Language	English