OutBack Power MATE3 User Manual

MATE3 Settings
900-0117-01-00 Rev B 111
Set Generator Total Run Time
The total running time for an automatic generator is displayed on the
Generator Status
screen, which is
accessed with the
Gen
hot key. (See page
46
59.) This menu allows the timer to be set to a different figure,
or to be reset to zero.
Figure 137 MATE3/AGS/Set Generator Total Run Time
Display AGS Timers
The
Display AGS Timers
screen is a read-only screen that provides the following information.
Programming of these values is done in the
Quiet Time Schedule, Voltage Start, Load Start,
Must Run Schedule,
or
State of Charge Start
menus described on pages 106 through
46
108.
Figure 138 MATE/AGS/Display AGS Timers Screen
Set points:

Generator Total Run Time – 0.0 to 999.9 hours
 Fault begins counting from zero
when no voltage is detected after a
generator start. When the
Fault Time setting is reached
according to the AGS Setup screen
on page
4106, an AGS fault will be
generated and an event will be
recorded (see page
461).

Warmup , Cool down , and
Exercise begin counting from zero
when each stage begins. The
generator will react accordingly
when their respective times are
reached according to the
AGS Setup screen on page 4106.
 2 Min , 2 Hour , and
24 Hour begin counting
down from the maximum
time when the respective
conditions are reached for
each setting. If any of
these timers reach zero,
the generator will be
started.
 Load Start and Load Stop begin
counting from zero when the
respective conditions are reached
for each setting. If either of these
timers reach the delay time as set
in the
Load Start screen on
page 4108, the generator will be
started or stopped as appropriate.
 DC Absorb is used with the DC
generator settings shown in
4Figure 123 on page 4106. It begins
counting from zero when the
DC Absorb Voltage is reached.
The generator will be stopped
when the DC Absorb Time
setting is reached.
Screen Items:

OutBack Power MATE3 Specifications

General

Brand	OutBack Power
Model	MATE3
Category	Controller
Language	English