Important Safety Instructions
900-0117-01-00 Rev B 3
General Safety
WARNING: Limitations on Use
This equipment is NOT intended for use with life support equipment or other
medical equipment or devices.
CAUTION: Equipment Damage
Only use components or accessories recommended or sold by OutBack Power
Technologies or its authorized agents.
IMPORTANT:
Do not attempt to install this equipment if it appears to be damaged in any
way. See the Warranty section for instructions on returning the equipment.
Personal Safety
WARNING: Personal Injury
Use standard safety practices when working with electrical equipment
(e.g., remove all jewelry, use insulated tools, wear cotton clothing, etc.)
Review the system configuration to identify all possible sources of energy.
Ensure ALL sources of power are disconnected before performing any
installation or maintenance on this equipment. Confirm that the terminals
are de-energized using a validated voltmeter (rated for a minimum
1000 Vac and 1000 Vdc) to verify the de-energized condition.
WARNING: Fire Hazard
Do not operate the unit with damaged or substandard cabling.
CAUTION: Equipment Damage
Strictly enforce clearance requirements and keep all vents clear of
obstructions that can inhibit air flow around or through the unit.
Sensitive electronics inside the equipment can be destroyed by static
electricity. Be sure to discharge any static electricity built up before
touching the equipment and wear appropriate protective gear.
Do not perform any servicing other than that specified in the installation
instructions unless qualified to do so and have been instructed to do so by
OutBack Power Technologies Technical Support personnel.
To Next Page
Loading...
Need help?
General
