OutBack Power MATE3 User Manual

900-0117-01-00 Rev B 69
Programming
Programming an OutBack system may involve the following settings.

System
settings (page
24
72). These include:
~
System Information
--------------------------------------- >
See page
4
73.
~
Save/Restore Configuration
--------------------------- >
See page
4
74.
~
Firmware Revision
----------------------------------------- >
See page
4
76.
~
Date and Time
----------------------------------------------- >
See page
4
74.
~
LCD Display
--------------------------------------------------- >
See page
4
77.
~
Sound
----------------------------------------------------------- >
See page
4
78.
~
Ethernet Addresses
---------------------------------------- >
See page
4
78.
~
Ethernet Ports
----------------------------------------------- >
See page
4
79.
~
Data Stream
-------------------------------------------------- >
See page
4
79.
~
System Name
------------------------------------------------- >
See page
4
79.
~
Installer Information
-------------------------------------- >
See page
4
80.
~
Installer Settings
------------------------------------------- >
See page
4
79.

Inverter
parameters (page
24
82). These include:
~
Search
----------------------------------------------------------- >
See page
24
82.
~
AC Input Current Limit
----------------------------------- >
See page
24
82.
~
Grid AC Input Voltage Limits
-------------------------- >
See page
24
84.
~
Gen AC Input Voltage Limits
--------------------------- >
See page
24
84.
~
AC Output
----------------------------------------------------- >
See page
24
85.
~
Low Battery
--------------------------------------------------- >
See page
24
85.
~
Battery Charger
--------------------------------------------- >
See page
24
86.
~
Battery Equalize
-------------------------------------------- >
See page
24
86.
~
Auxiliary Output
-------------------------------------------- >
See page
24
87.
~
Inverter Stacking
------------------------------------------- >
See page
24
89.
~
Grid-Tie Sell
--------------------------------------------------- >
See page
24
91.
~
Calibrate
------------------------------------------------------- >
See page
24
92.
~
Reset Inverter to Factory Defaults
------------------- >
See page
24
93.

Charge Controller
limits (page
24
94). These include:
~
Charger
--------------------------------------------------------- >
See page
24
94.
~
MPPT
------------------------------------------------------------ >
See page
24
95.
~
Temperature Compensation
--------------------------- >
See page
24
96.
~
Battery Equalize
-------------------------------------------- >
See page
24
96.
~
Grid Tie Mode
----------------------------------------------- >
See page
24
97.
~
Auxiliary Output
-------------------------------------------- >
See page
24
97.
~
Restart Mode
------------------------------------------------- >
See page
24
100.
~
Calibrate
------------------------------------------------------- >
See page
24
100.
~
Reset to Factory Defaults
-------------------------------- >
See page
24
101.

Battery Monitor
parameters (page
24
102). These include:
~
Battery Setup
------------------------------------------------ >
See page
24
102.
~
Shunt Enable
------------------------------------------------- >
See page
24
102.
~
Relay Mode
---------------------------------------------------- >
See page
25
103.
~
Relay Set Points
--------------------------------------------- >
See page
25
103.
~
Reset FLEXnet DC to Factory Defaults
-------------- >
See page
25
104.

OutBack Power MATE3 Specifications

General

Brand	OutBack Power
Model	MATE3
Category	Controller
Language	English