System Settings
900-0117-01-00 Rev B 81
Change Installer Password
The
Change Installer Password
screen allows changes to the Installer Password so that access to the full
menus can be restricted to those who know the new password (OEMs or installers).
IMPORTANT:
Changes to system settings should only be made by qualified personnel or
under the direction of OutBack Technical Support.
Figure 88 Change Installer Password
Challenge Installer Password
If the installer password is lost or forgotten, this process is used to reset access to the device. The screen
will generate a challenge code as shown below. Once the installer has the challenge code, it is necessary
to contact OutBack Technical Support (see inside front cover) to obtain a temporary installer password that
corresponds with the MATE3-generated challenge code. After entering the temporary installer password,
the installer should change the password according to their preferences.
Figure 89 Challenge Installer Password
Set Points:
Set points include four numerical digits from
0
to
9
.
The default Installer Password is
1732
.
Set Points:
Set points include four numerical digits from
0
to
9
.
To Next Page
Loading...
Need help?
General
