EVO Installation Guide 111
C.0.14 Muting
SECTION [004]: OPTION [1]
C.0.15 Beep on Exit Delay
SECTION [004]: OPTION [2]
C.0.16 Chime on Zone Closure
SECTION [004]: OPTION [4]
C.0.17 Beep on Trouble
SECTION [005]: OPTIONS [1] TO [4]
C.0.18 Keypad Tamper Enable
SECTION [006]: OPTION [5]
C.0.19 Combus Voltmeter
1. From Normal Mode press and hold the [0] key.
2. Enter the [
INSTALLER CODE] (Default: 000000).
3. Press [
ACC].
Note:The voltage may drop during the control panel battery test.
Programmable Output Options
C.0.20 PGM State
SECTION [006]: OPTION [1]
Note:The PGM can provide 50mA to any device connected to it.
Option [1] OFF = Audible sounds (default)
Option [1] ON = Mute
Option [2] OFF= Exit Delay beep disabled
Option [2] ON= Exit Delay beep enabled (default)
Option [4] OFF = Chime on Zone Closure disabled (default)
Option [4] ON = Chime on Zone Closure enabled
O
ption [1] OFF =
Beep disabled: System Troubles and Clock Loss
(default)
Option [1] ON = Beep enabled: System Troubles and Clock Loss
Option [2] OFF = Beep disabled: Communicator Troubles (default)
Option [2] ON = Beep enabled: Communicator Troubles
Option [3] OFF = Beep disabled: Module and Bus Troubles (default)
Option [3] ON = Beep enabled: Module and Bus Troubles
Option [4] OFF = Beep disabled: all Zone Troubles (default)
Option [4] ON = Beep enabled: all Zone Troubles
Option [5] OFF = Keypad's tamper is disabled (default)
Option [5] ON = Keypad's tamper is enabled
Option [1] OFF= PGM is Normally Open (default)
Option [1] ON= PGM is Normally Closed
To Next Page
Loading...
